Rockwell Automation FlexPak Plus NRG DC Drive - Manual (Page 3)

2
DANGER
CONTROLLER EQUIPMENT IS AT LINE VOLTĆ
AGE WHEN AĆC POWER IS CONNECTED TO
THE POWER UNIT IN THE FLEXPAK PLUS
CONTROLLER. THUS AĆC POWER MUST BE
REMOVED FROM THE UNIT BEFORE IT IS SAFE
TO TOUCH INTERNAL PARTS OF THE CONĆ
TROLLER. PERSONAL INJURY MAY RESULT
UNLESS POWER IS REMOVED.
WARNING
THE NATIONAL ELECTRICAL CODE REQUIRES
THAT AN N.E.C. APPROVED FUSED DISCONĆ
NECT SWITCH OR CIRCUIT BREAKER BE
USED AHEAD OF THE CONTROLLER AND
POWER TRANSFORMER (IF USED) ON THE
INCOMING AĆC LINE. PERSONAL INJURY MAY
RESULT IF AN EASILY ACCESSIBLE MEANS OF
LINE VOLTAGE DISCONNECTION IS NOT PROĆ
VIDED.
WARNING
DO NOT OPERATE THE FLEXPAK PLUS CONĆ
TROLLER ON POWER SUPPLIES WITH AVAILĆ
ABLE SHORTĆCIRCUIT CURRENTS IN EXCESS
OF 5000 AMPERES. DAMAGE TO EQUIPMENT
AND PERSONAL INJURY MAY OCCUR.