Baumfolder BAUM 26_30: Folder 1st Station Contfeed - Manual (Page 10)

TP10476-1 PAGE 10
INTRODUCTION OVERVIEW
The 1st station (parallel) folder with continuous
feeder contains the following main components (Figure 1):
1. Continuous Feeder
2. Register
3. 1st Station Folder (Parallel)
4. Fold Roller Baumset settings
5. Fold Plates
6. Slitter Shafts (not shown)
7. Delivery (Stacker, not shown)
8. Operator Controls
9. Double Sheet Detector (not shown)
10. Vacuum Pump (not shown)
11. Handwheel
Figure 2
Figure 1
TRANSPORTATION/INSTALLATION
As soon as you receive your new folder, and before
removing the machine from the skid, check carefully for any
damage to the shipments. If any damage is found, promptly
contact your Baumfolder sales representative.
To lift the folder from the skid, place the fork lift rails
under the crossmembers as shown in Figure 2. Note that the
fork lift must have at least a 1500 lb. capacity.
Remove all rust protection coating after unpacking the
folder.
5
11
8
3
1
149"
68"
46"
265"
54.5"
(3.03m)
119"
77.5"
(1.97m)
(1.38m)
(1.17m)
(1.73m)
(6.73m)
(3.78m)
Remove the connecting bolts from the side frame at the
front of the register. Move the feeder next to the properly
aligned fold head and adjust it so that the holes in the
register and in the side of the folder are at the same height.
Remove the transport supports after you
align the feeder.
Install the drive belts on the folding unit and check
their tension.(Figure 3)
Figure 3
4
2
BAUM 30
BAUM 26