Baumfolder BAUM 26_30: Folder 1st Station Contfeed - Manual (Page 22)

TP10476-1 PAGE 22
.
P13: Setup Time
Select this parameter to view the Setup time in hours (decimals). The time indicator is reset to zero for a new
job.
P14: Pause Time
Select this parameter to view the time during which the machine is held by the Pause function (P23 enabled).
The time is shown in hours (decimals) and reset to zero when new operating data is entered.
P15: Current Job No.
Note: This parameter is only displayed when the network is activated in Service mode. Not available in Soft-
ware Version 100.300.
P16: Personnel No.
This parameter is only displayed when the network is activated in Service mode. Not available in Software
Version 100.
P26 Software Version Automatic from RAM Fixed e.g. dCt 3.0.1
P27 Machine Type In Service mode Fixed e.g. P-36
P28 Serial Port type In Service mode Fixed e.g. off
Large contr. display dsP
Table 3Machine settings Network net
+
+
+
+
# Function Operation Key Combin. Variable Displayed
P20 Units Adjustable with Standard Inches
Meters
P21 Language Adjustable with Standard English
German
Codes
P22 Network address Function not enabled
P23 Pause Time On/Off Adjustable with Standard - Disabled 0
Release 1
Adjustable with Activated
Adjustable with Deactivated
P24 Network Function not enabled
P25 Easy Mode Adjustable with Default setting 0
only on C-2020, P-2020
P12: Production stoppage time
Select this parameter to view the time during which the machine is not operating. The Pause function and Sheet
feed are disabled. The time is shown in hours (decimals) and reset to zero for a new job.
P20:Units
Use this parameter to select the unit of measurement (meters or inches) for the values which appear in Displays
01 and 02.
P21: Language
Use this parameter to select the language (English, German or code) for the Display (01) messages.
P22:Network Address
Only indicated when the "Network" option is selected and enabled in the Service menu. Not available in Soft-
ware Version 100.300.