Baumfolder BAUM 26_30: Folder 1st Station Contfeed - Manual (Page 28)

TP10476-1 PAGE 28
Exit Learn Mode
Pressing any of these keys will cause the controller to change
to a new mode.
2.4 Make Ready Mode
When this button is pushed, its LED toggles. When the LED
is on, the folder will only feed single sheets and a batching
output is issued for every two sheets fed. This allows the
operator to easily set up the batching time. Make ready is
deactivated when learn mode is started.
Pressing any of these keys will exit Make Ready Mode.
2.5 Network Job Mode
Pushing this key puts the counter in network job mode
This mode is only available if a STA-NET adapter is
installed and activated through maintenance mode. In this
mode the small display (2) always shows the word ‘Job’. The
large display (1) shows either ‘Pause’ or a job number which
can be read from the network. The suction length display is
disabled.
Sheet Length Setting Resultant Suction Length Percentage.
Greater than or equal to 30 cm. 30% of Sheet Length
Less than 30 cm., and greater than or equal to 27 cm. 25% of Sheet Length
Less than 27 cm., and greater than or equal to 24 cm. 20% of Sheet Length
Less than 24 cm., and greater than or equal to 21 cm. 15% of Sheet Length
Less than 21 cm. 10% of Sheet Length.
Table 12. Suction Length Function
Select Job Number
This set of plus and minus keys step the large display (1)
through pause mode and a list of available job numbers.
While in network job mode, the folder is considered to be
paused.
Load Job and Return to Run Mode
When this button is pushed, the selected job will be loaded
into the counter and the counter will return to run mode. If
the large display (1) was showing the message ‘PauSE’, the
network job mode will end, but no job will be loaded.
Exit Network Job Mode
Pressing any of these keys will cause the counter to change
to a new mode.
+ +
h
0
h 0
h
0