Baumfolder BAUM 26_30: Folder 1st Station Contfeed - Manual (Page 13)

PAGE 13 TP10476-1
Stack feeding is stopped automatically if the tab of the
switch is pushed beyond a preset point by the leading sheet
edge (6-3).
Make certain that the switch tab remains
in a verticle position during the sheet
feed operation and that it does not
vibrate (flutter) with each passing sheet.
The position of the switch tab is set at the factory. If
necessary, it can be adjusted both horizontally and vertically
by knobs located on the feeder side frame.
Place the lateral blower (7-1) along the edge of the sheet
stack and the holddown wheels (7-2) on the trailing edge of
the top feeding sheet.
Figure 6
2 1
Figure 7
3
1 2
1.1 Air and Vacuum Settings
Use knob (8-1) to adjust the height of the front blowers
and set the angle of the air flow with the lever (8-2) above
the knob. The pointer on the operator side shows airflow
direction.
Use knob (8-3) to adjust the position of the transfer plate.
The distance between the top of the stack and the bottom
of the sucker wheel should be about 1 cm. Lift the
transport plate for large sheets or drooping sheet edges.
Lower the transport plate for small sheets.
Use knob (8-4) to adjust the air volume that the suction
plate blowers produce.
Use knobs (8-5 thru 8-8) to adjust the air volume pro-
duced by the front blowers separately for each section.
Symbols by the knobs indicate the zone which each
knob regulates.