Metrohm tiamo 2.3 Patch 1 - Manual (Page 1165)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 Patch 1 ￭￭￭￭￭￭￭￭ 1149
Selection Device types | Titrando
Default value Titrando
Sensor
Measuring input
Selection of the measuring input the sensor is connected to.
Titrando, 867
Selection
1 | 2
Default value 1
855
Selection
1
Default value 1
Titrino
Selection
1 | 2 | diff
Default value 1
Sensor
Selection of a sensor of type pH electrode from the list of sensors availa-
ble in the sensor table. The calibration data for the sensor will be adopted
for the determination.
Selection Sensor name | pH electrode
Default value pH electrode
Temperature measurement
Type of temperature measurement.
Titrando, 855, 867
Selection
continuous | automatic | off
Default value automatic
continuous
A temperature sensor must be connected. The temperature will then
be measured continuously.
automatic
If a temperature sensor is connected then the temperature will be
measured continuously. Otherwise, the temperature entered manually
under Temperature will be used.
off
The temperature will not be measured. The temperature entered man-
ually under Temperature will be used.