Metrohm tiamo 2.3 Patch 1 - Manual (Page 1580)

7.16 089 Photometer ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1564 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
7.16.5 Properties - MSB #
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ MSB #
On the tabs MSB # the properties of the connector and the devices con-
nected to are displayed.
Request for dosing device preparation
Selection when the request for carrying out the command PREP (see
Chapter 5.6.6.5.1, page 1200) (prepare) is to be shown for the dosing
device connected to the MSB.
At program start
on | off (Default value: on)
If this option is switched on then at each program start the request to pre-
pare the dosing device will appear.
On attaching an exchange/dosing unit
on | off (Default value: on)
If this option is switched on then at each attaching of an exchange or dos-
ing unit the request to prepare the dosing device will appear.
Time interval
on | off (Default value: off)
If this option is switched on then the request to prepare the dosing device
will appear after the time interval defined here.
all
Time interval after which the request to prepare the dosing device will
appear.
Range 0.1 ... 999.9 h
Default value 12 h
Connected devices
Information about the following peripheral devices connected to the MSB
connector appears here:
Dosing device 1
Dosing device type
Display of the dosing device type.
Dosing device serial number
Display of the serial number of the connected dosing device.