Metrohm tiamo 2.3 Patch 1 - Manual (Page 1383)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.3 Patch 1 ￭￭￭￭￭￭￭￭ 1367
6.5.3 Device properties
Dialog window: Configuration ▶ Devices ▶ [Edit] ▶ Properties… ▶ Properties - 'De-
vice type' - 'Device name'
With the menu item [Edit] ▶ Properties... in the subwindow Devices,
the properties window opens for the device selected in the device table in
which the parameters of the device can be edited. It consists of several
tabs. The tabs General and GLP are always present, the remaining tabs
depend on the selected device. Properties can be set for the following
devices:
￭ Titrando
￭ Titrino
￭ 756/831 Coulometer
￭ 712 Conductometer
￭ 856 Conductometer
￭ 867 pH Module
￭ 846 Dosing Interface
￭ 730 Sample Changer
￭ 774 Oven Sample Processor
￭ 778/789 Sample Processor
￭ 814/815 Sample Processor
￭ 855 Robotic Titroprocessor
￭ 864 Balance Sample Processor
￭ 874 Oven Sample Processor
￭ Avantes Spectrometer
￭ RS-232 device
￭ Balance
￭ Barcode reader
6.6 Subwindow Titrants/Solutions
6.6.1 Titrants/Solutions - General
Subwindow: Configuration ▶ Titrants/Solutions
Subwindow Titrants/Solutions
The subwindow Titrants/Solutions contains the solution table with all
automatically recognized and manually added titrants and auxiliary solu-
tions. It can be shown in a separate window in the program part Config-
uration as a part of the Configuration view or (if not present on the desk-
top) with View
▶ Quick access. The subwindow can be enlarged and
reduced as required; it can also be maximized.
Titrants
Titrants are used as solutions for the titration commands DET, MET, SET,
KFT and STAT. They can be used in exchange units or dosing units.