Metrohm 789 Robotic Sample Processor XL - Manual (Page 69)

3.2 Configuration
Metrohm Sample Processor, Operation 61
3.2.3 Rack definitions
configuration
>rack definitions
Submenu for defining individual racks
Open the submenu with <ENTER>
>rack definitions
>>recall rack
Loads rack definitions
In order to make a modification to the definition of a sample rack the rack
data must first be loaded. The data of the Metrohm standard racks is stored
under their ordering number.
>recall rack
name: 6.2041.310
Name of the rack to be loaded
10 ASCII characters
The <SELECT> key can be used to make a selection from the saved rack
data. The rack data is loaded with <ENTER>. The first selection to appear
is the rack name of the currently attached rack.
>recall rack
code 000001
Magnet code of the rack
See table on p. 91.
000001…111111
The magnet code is used for the unambiguous identification of the rack. The
magnet code is recognized during the initialization of the rack. This is why
the <RACK> key should be pressed whenever a rack is changed.
>recall rack
work position T1 0 mm
Working position for sample positions at
Tower 1 * )
0…235 mm (in mm from upper stop point)
>recall rack
work position T2 0 mm
Working position for sample positions at
Tower 2 * )
0…235 mm (in mm from upper stop point)
>recall rack
rinse position T1 0 mm
Rinsing position for sample positions at
Tower 1 *
)
0…235 mm (in mm from upper stop point)
>recall rack
rinse position T2 0 mm
Rinsing position for sample positions at
Tower 2 *
)
0…235 mm (in mm from upper stop point)
>recall rack
shift position T1 0 mm
Shifting position for sample positions at
Tower 1 *
)
0…235 mm (in mm from upper stop point)
Use <QUIT>
for next higher
level