Banner Q60 Background Suppression Series - Manual

Q60AFV Series Sensors with Visible Red Emitter
Self-Contained Adjustable-Field Sensors
Printed in USA 02/12 P/N 69622 rev. B
Q60AFV Adjustable-Field Features
• Adjustable-field background suppression sensor detects objects within a defined sensing
field, while ignoring objects located beyond the sensing field cutoff
• Two-turn, logarithmic adjustment of sensing field cutoff point from 0.2 to 1 m; allows easy
setting of cutoff point at long range
• Rotating pointer indicates relative cutoff point setting
• Easy push-button or remote programming of light/dark operate and output timing;
continuous status indicators verify all settings at a glance
• Output ON and/or OFF delays adjustable from 8 milliseconds to 16 seconds
• Powerful, highly collimated visible red sensing beam
• Tough ABS/polycarbonate blend housing is rated IEC IP67; NEMA 6
10-30V dc Models (Q60BB6AFV):
• Powered by 10 to 30V dc; bipolar (one NPN and one PNP) outputs
• Available with integral cable or rotating Euro-style quick-disconnect fitting
Universal Voltage Models (Q60VR3AFV):
• 12-250V dc or 24-250V ac, 50/60 Hz
• Available with integral cable or rotating Micro-style quick-disconnect fitting
Visible Red, 665 nm
Q60 Adjustable-Field Models
* 9 meter cables are available by adding suffix “W/30” to the model number of any cabled sensor (e.g., Q60BB6AFV1000 W/30).
A model with a QD connector requires a mating cable; see page 8.
Q60BB6AFV1000
65 mm
to 130 mm
(2.5" to 5")
depending
on cutoff
point setting
5-wire
2 m (6.5')
10-30V dc
Bipolar
NPN/PNP
1
10
100
10 mm
0.4 in
100 mm
4 in
1000
40 in 1 mm
0.04 in
E
X
C
E
S
S
G
A
I
N
DISTANCE
1000
10000
Q60AFV
Models
Minimum
Range Cable*
Supply
Voltage
Output
Type
Excess Gain at
200 mm Cutoff
Adjustable:
200 mm to
1000 mm
(8" to 40")
Cutoff
Point
1
10
100
10 mm
0.4 in
100 mm
4 in
1000 mm
40 in
1 mm
0.04 in
E
X
C
E
S
S
G
A
I
N
DISTANCE
1000
10000
Q60AFV
Excess Gain at
1000 mm Cutoff
Q60BB6AFV1000Q
5-pin
Euro-style
QD
WARNING . . .
Not To Be Used for Personnel Protection
Never use these products as sensing devices for personnel protection. Doing so could lead to serious injury or death.
These sensors do NOT include the self-checking redundant circuitry necessary to allow their use in personnel safety applications. A
sensor failure or malfunction can cause either an energized or de-energized sensor output condition. Consult your current Banner Safety Products
catalog for safety products which meet OSHA, ANSI and IEC standards for personnel protection.
!
Q60VR3AFV1000
5-wire
2 m (6.5')
Universal
Voltage
12-250V dc
or
24-250V ac
E/M Relay
(SPDT),
normally
closed and
normally open
contacts
Q60VR3AFV1000Q1
4-pin
Micro-style
QD
E/M Relay
(SPST),
normally
open
contact