Banner U-GAGE Q45UR Series—Analog - Manual (Page 8)

U-GAGE ™ Analog Q45UR Remote Ultrasonic Sensors
8
P/N 59323 Rev. C
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
Vibration and
Mechanical Shock
Application Notes
All models meet Mil. Std. 202F requirements. Method 201A Vibration: 10 to 60Hz max., double amplitude
0.06" (maximum acceleration 10G). Method 213B conditions H & I (Shock: 75G with unit operating; 100G
for non-operation). Also meets IEC 947-5-2 requirements: 30G, 11 ms duration, half sine wave.
Certifications
Connections Controller: 2m (6.5') or 9 m (30') attached cable, or 5-pin Mini-style or Euro-style quick-disconnect fitting
Sensor:
2m (6.5') attached PVC cable terminated with 4-pin Euro-style quick-disconnect fitting for
connection to controller
The controller has non-volatile memory which remembers the last sensing window setting if power is
removed and later reapplied.
The sensing window may be programmed via the Remote Teach input (see hookup diagrams).
Acceptable target angle is within ±5º of normal for a smooth, flat target; target rotation does affect the
apparent target location with respect to the sensor.
Q45UR Controller with 5-Pin
Mini-Style QD
(“Q” Model Suffix)
Q45UR Controller with
Attached Cable
Q45UR Controller with 5-Pin
Euro-Style QD
(“Q6” Model Suffix)
5-Pin Mini-Style Pin-Out
(Cable Connector Shown)
5-Pin Euro-Style Pin-Out
(Cable Connector Shown)
Q45UR Series Controller Hookups
bn
wh
bu
+
–
bk
ye or gy
Load
15-24V dc
Remote Teach
(+5-24V dc)
Load
shield*
4 to 20 mA
0 to 10V
bn
wh
bu
+
–
bk
ye
Load
Load
15-24V dc
Remote Teach
(+5-24V dc)
shield*
4 to 20 mA
0 to 10V
bn
wh
bu
+
–
bk
gy
Load
Load
15-24V dc
Remote Teach
(+5-24V dc)
shield*
4 to 20 mA
0 to 10V
Black Wire
Blue Wire Brown Wire
Yellow Wire
White Wire
White Wire
Blue Wire
Black Wire
Brown Wire
Gray Wire
Operating Temperature Controller and sensor: -25° to +70°C (-13° to +158°F)
Maximum relative humidity: 85% (non-condensing)
Analog Q45UR Series Specifications, continued
* It is recommended that the shield wire be
connected to earth ground or dc common.
D