Banner WORLD-BEAM QS18 Series - Manual (Page 10)

Fiber Optic - Plastic
Excess Gain Beam Pattern Excess Gain Beam Pattern
Performance using Dark Set, performed in no-light condition.
Wiring Diagrams
Cabled wiring diagrams are shown. Quick disconnect (QD) wiring diagrams are functionally identical.
NPN (Sinking) Outputs
3
1
4
2
10-30V dc
Remote
Programming
(N.O.)
+
–
Load
PNP (Sourcing) Outputs
3
1
4
2
10-30V dc
+
–
Remote
Programming
(N.O.)
Load
Specifications
Supply Voltage
10 to 30 V dc (10% maximum ripple) at less than 35
mA, exclusive of load; 10 to 24 V dc at > 55º C
Supply Protection Circuitry
Protected against reverse polarity and transient
voltages
Output Configuration
Current sourcing (PNP) or current sinking (NPN),
depending on model; Light- or dark-operate
selectable; Selectable 30 ms output OFF-delay
Rating: 100 mA max
Off-state leakage current: less than 50 µA @ 30 V
dc (see Application Note 1)
ON-state saturation voltage: less than 1.5 V @ 100
mA (1.7V for 30 ft cable models)
Output Protection Circuitry
Protected against false pulse on power-up and
continuous overload or short-circuit of output
Output Response
NOTE: Momentary delay on power-up; output does
not conduct during this time
600 µs ON/OFF
Repeatability
75 µs
Construction
ABS housing, PMMA lens
Connections
PVC-jacketed 4-conductor 2 m (6.5 ft) or 9 m (30 ft)
unterminated cable, or 4-pin Euro-style or 4-pin Pico-
style quick-disconnect (QD), either integral or 150
mm (6 in) pigtail, are available. QD cordsets are
ordered separately.
Operating Conditions
Temperature: –20 °C to 70 °C (–4 °F to 158 °F)
Relative Humidity: 90% @ 50 ºC (non-condensing)
Application Notes
If the push button does not appear to be responsive,
perform the push button enable procedure
To maintain backwards compatibility with earlier
models, 3 remote line pulses or a push button hold
followed by 3 push button clicks will perform a Dark
SET.
Certifications
WORLD-BEAM ® QS18E Series
10 www.bannerengineering.com - tel: 763-544-3164 P/N 136564 Rev. C