Banner R58 Registration Mark Sensors - Manual

Printed in USA 03/09 P/N 122928 rev. C
R58E Series Expert
™
Registration Mark Sensors
Registration Mark Sensor with Three-Color Light Source
WARNING . . .
Not To Be Used for Personnel Protection
Never use these products as sensing devices for personnel protection. Doing so could lead to serious injury or death.
These sensors do NOT include the self-checking redundant circuitry necessary to allow their use in personnel safety applications. A sensor failure or
malfunction can cause either an energized or de-energized sensor output condition. Consult your current Banner Safety Products catalog for safety products which meet
OSHA, ANSI and IEC standards for personnel protection.
Features
Ultra-fast 10 kHz switching frequency •
Red, green, and blue LEDs evaluated during TEACH to optimize application contrast, •
with the best color automatically selected by the sensor; sensing beam colors also
may be individually disabled
Outstanding color contrast sensitivity; detects 16 levels of gray scale
•
Smart gain-control algorithm to maximize performance in low-contrast or high-gloss •
applications
Easy-to-set, automatic
• Expert-style configuration options include Static and Dynamic
TEACH, plus Manual Adjust for fine tuning
Easy-to-read 8-segment bargraph display indicator for TEACH and signal strength
•
readout, plus indicators for continuous readout of output status and setup
Fixed-convergent sensing at 10 mm ±3 mm (0.39" ±0.12")
•
Rectangular 1.2 mm x 3.8 mm (0.05" x 0.15") sensing image at 10 mm (0.39") from •
the lens
Parallel or perpendicular sensing image, depending on model (see below)
•
Rugged zinc alloy die-cast housing with high-quality acrylic lens suitable for food •
processing applications; rated IP67, NEMA 6
Easy selection of Light/Dark Operate (LO/DO), 30 ms pulse stretcher (OFF-delay),
•
and 30 ms ON-delay, via push buttons or a remote input wire
Models
* 9 m cables are available by adding suffix “W/30” to the model number of any cabled sensor (e.g., R58ECRGB1 W/30).
A model with a QD connector requires a mating cable; see page 10.
Models Cable* Focus Supply Voltage Output Type Sensing Image Orientation
R58ECRGB1 5-wire 2 m (6.5')
10 mm
(0.39")
10 to 30V dc
Bipolar
NPN/PNP
R58ECRGB1Q8 5-pin Euro-style integral QD
R58ECRGB1Q 5-pin Euro-style QD pigtail
R58ECRGB2 5-wire 2 m (6.5')
R58ECRGB2Q8 5-pin Euro-style integral QD
R58ECRGB2Q 5-pin Euro-style QD pigtail
Parallel to sensor length
Perpendicular to sensor length
Parallel to sensor length
Perpendicular to sensor length