Tweco PAK 200i User Manual
Operating manual, 200i, Plasma cutting system
Advertising
Table of contents
Document Outline
- SECTION 1: GENERAL INFORMATION
- SECTION 2: SPECIFICATIONS
- SECTION 3: INSTALLATION
- 3.01 Installation Requirements
- 3.02 Cables and Leads Identification
- 3.03 Cables & Leads Identification
- 3.04 Position the Power Supply
- 3.05 Primary Power Connections
- 3.06 Connect Work Cable
- 3.07 Connect Gas Supply Lines
- 3.08 Auxiliary Connections
- 3.09 Connect Torch Leads to the Arc Starter
- 3.10 Torch Parts Selection
- 3:11 Fill Cooling System
- 3.01 Installation Requirements
- SECTION 4: OPERATION
- SECTION 5: MAINTENANCE
- SECTION 6: REPLACEMENT ASSEMBLIES & PARTS
- 6.01 Replacement Power Supply
- 6.02 Leads and Cables
- 6.03 Power Supply External Replacement Parts
- 6.04 Power Supply Replacement Parts - Lower Right Side
- 6.05 Power Supply Replacement Parts - Upper Right Side
- 6.06 Power Supply Replacement Parts - Lower Left Side
- 6.07 Power Supply Replacement Parts - Upper Left Side
- 6.08 Power Supply Replacement Parts - Rear Panel
- 6.09 Power Supply Replacement Parts - Front
- 6.10 Recommended Gas Supply Hose
- 6.01 Replacement Power Supply
- SECTION 7: TORCH MAINTENANCE
- Appendix 1: Control Module
- Appendix 2: CCM CPU PCB Layout
- Appendix 3: CCM I/O PCB Layout
- Appendix 4: Pilot PCB Layout
- Appendix 5: Relay and Interface PCB Layout
- Appendix 6: Display PCB Layout
- Appendix 7: System Bias PCB Layout
- Appendix 8: Main Inverter Bottom PCB Layout
- Appendix 9: Main Inverter Top PCB Layout
- Appendix 10: Control and Fault PCB Layout
- Appendix 11: Cap Bias Bottom PCB Layout
- Appendix 12: Cap Bias Top PCB Layout
- Appendix 13: Suppressor PCB Layout
- Appendix 14: gas box layout
- Appendix 15: COOLING DIAGRAM
- Appendix 16: System Schematics
- Appendix 17: Advanced Troubleshooting
- Appendix 18: Publication History