Tweco CutMaster 12mm-20mm-25mm User Manual
Page 3
!
WARNING
Read and understand this entire Manual and your employer’s safety practices before installing, operat-
ing, or servicing the equipment.
While the information contained in this Manual represents the Manufacturer's best judgement, the
Manufacturer assumes no liability for its use.
Plasma Cutting Power Supply
CutMaster™ 12mm
SL60 1Torch™ Operating Manual No.: 0-5117
CutMaster™ 20mm
SL60 1Torch™ Operating Manual No.: 0-5117
CutMaster™ 25mm
SL60 1Torch™ Operating Manual No.: 0-5117
Published by:
Thermal Dynamics Corporation
82 Benning Street
West Lebanon, New Hampshire, USA 03784
(603) 298-5711
www.thermal-dynamics.com
Copyright 2008, 2009, 2010, 2011, 2012 by
Thermadyne Corporation
All rights reserved.
Reproduction of this work, in whole or in part, without written permission of the publisher is
prohibited.
The publisher does not assume and hereby disclaims any liability to any party for any loss or
damage caused by any error or omission in this Manual, whether such error results from negli-
gence, accident, or any other cause.
Original Publication Date: October 30, 2008
Revision Date: April 25, 2012
Record the following information for Warranty purposes:
Where Purchased:_________________________________________________
Purchase Date:__________________________________ __________________
Power Supply Serial #:___________________________ ___________________
Torch Serial #:_____________________________________________________
i