Tweco SC-3000 - Manual (Page 30)

SC-3000
INSTALLATION 3-8 Manual 0-5100
LINEAR DRIVE - CHECK OF COLLISION PROTECTION
1. Push the torch clamp out of it’s normal position until the recess is left and release it again.
Check: The torch must return into correct vertical direction.
2. If the torch doesn’t safely return into the vertical direction then check that the hose does not hin-
dered the deflection. If necessary correct the position of the hose.
However if the torch does not move exactly to the vertical direction then increase the deflection
loading force:
3. Turn adjusting screw clockwise with a hex-wrench #5mm.
Push here
Ensure that deflection is not
blocked when adjusting screw has
been driven to hard.
Put in hex. wrench
#5mm
Hex. wrench #5mm
Collision
Protection Unit
Hose Clamp
Art # A-08907
CAUTION!
Turn clockwise only as far as necessary to maintain sufficient deflection. The adjustment range of the vertical de-
flection force is from 30 to 120 N. If this is not maintained, the built-in collision switch doesn’t function and the
unit may be damaged in case of collision.