Tweco SC-3000 - Manual (Page 46)

SC-3000
OPERATION 4-6 Manual 0-5100
CUTTING SETTINGS
For detailed explanation go to section 4.12.
Mode Select
Device Info
ESC Parameter Cutheight
Dependent on choice of
control mode
Pierce Delay
Dynamic
Elevation Height
Retract Position
Pierce Height
Control Delay
Upper Threshold
Gas Pre-Flow
System Properties
OK
Main Menu
Cutting Height
Select mm / inch
End of Cut
Operator Terminal
Display
Cutting Height
Ideal Voltage
Real Voltage
Time during piercing
Starts with signal START XY
Additional lifting during ignition
Distance during igntion
Reaction rate of clearance control
Blocking of clearance control when crossing kerfs
Height after end of cutting
Gas Pre-Flow starts with START INITIAL POSITION FINDING
Setting in percent of ideal arc voltage to detect end of cut
standard setting 85%
Height during cutting
Art # A-08930