Tweco 252i Fabricator - Manual (Page 26)

FABRICATOR 252i INTRODUCTION
INTRODUCTION 2-2 Manual 0-5155
2.04 Description
The Tweco Fabricator 252i is a self contained single phase
multi process welding power source that is capable of
performing MIG (GMAW/FCAW), STICK (SMAW) and Lift
TIG (GTAW) welding processes. The Fabricator 252i is
equipped with an integrated wire feed unit, digital volt age
/ amperage meters, power factor correction (PFC) with
energy saving technology and a host of other features to
satisfy the broad operating needs of the modern welding
professional.
The Fabricator 252i is fully compliant to standard IEC
60974.1. The Fabricator 252i MIG provides excellent
welding performance across a broad range of applica-
tions when used with the correct welding consumables
and procedures. The following instructions detail how to
correctly and safely set up the machine and give guidelines
on gaining the best efficiency and quality from the Power
Source. Please read these instructions thoroughly before
using the unit.
2.05 User Responsibility
This equipment will perform as per the information con-
tained herein when installed, operated, maintained and
repaired in accordance with the instructions provided.
This equipment must be checked periodically. Defective
equipment (including welding leads) should not be used.
Parts that are broken, missing, plainly worn, distorted or
contaminated, should be replaced immediately. Should
such repairs or replacements become necessary, it is
recommended that such repairs be carried out by appro-
priately qualified persons approved by Tweco. Advice in
this regard can be obtained by contacting an Accredited
Tweco Distributor.
This equipment or any of its parts should not be altered
from standard specification without prior written approval
of Tweco. The user of this equipment shall have the sole
responsibility for any malfunction which results from
improper use or unauthorized modification from standard
specification, faulty maintenance, damage or improper re-
pair by anyone other than appropriately qualified persons
approved by Tweco.
2.06 Transportation Methods
WARNING
ELECTRIC SHOCK can kill. DO NOT TOUCH
live electrical parts. Disconnect input power
conductors from de-energized supply line
before moving the welding power source.
WARNING
FALLING EQUIPMENT can cause serious per-
sonal injury and equipment damage.
Lift unit with integrated hand holds at the front and rear
of the unit.
Use handcart or similar device of adequate capacity.
If using a fork lift vehicle, place and secure unit on a proper
skid before transporting.