Tweco 252i Fabricator - Manual (Page 41)

INSTALLATION/SETUP FABRICATOR 252i
Manual 0-5155 3-11 INSTALLATION/SETUP
TIG
Process
MIG
STICK
If the welder is in Advanced Features mode and the Weld Process Selection button (Control No 3) is pressed, the
welder will exit Advanced Features mode, saving any change made, and change to the next weld process function
in the sequence: MIG, LIFT TIG, STICK. (See previous note) If you wish to view the Advanced Features for the next
process you will need to enter the Advanced Features function again.
ARC CONTROL
V
Right Knob
If the welder is in Advanced Features mode and the right knob (Control No 7) is pressed for one (1) second (to enter
Arc Control Function) the welder will exit Advanced Features mode, saving any change made, and enter the Arc Control
Function for the currently selected weld process.
MIG (GMAW/FCAW)Mode Advanced Features Menu Map
RUN- / IN
POST / FLOW
BURN / BACK
WIRE / SHRP
Advanced Menu – MIG
Mode
Wire Feed Speed
ARC- / TYPE
MIG / CNTL
PRE- / FLOW
SPOT
STCH
DWEL / TIME
ON OFF
*STCH / TIME
AUTO CV
Advanced Menu - MIG
Options or Range
Press Advanced Button
to Exit to Welding Mode
LOCL REMT
0.1 - 5.0 S
MPM IPM WFS- / UNIT
30 - 150%
0.0 - 30.0 S
0.00 - 1.00 S
0.1-20.0 S
FACT / DFLT
HR
*SPOT / TIME
0.2 - 4.0 S
0.1 - 1.0 S
0.0 - 9999.9
NO YES
Press Advanced Button
to Exit to Welding Mode
Left Display Right Display
ON OFF
ON OFF
Left Knob Selection
* SPOT TIME and STCH TIME are only active when SPOT or STCH are “ON”.
Note “SPOT” and “STCH” are MUTUALLY EXCLUSIVE functions. If the user enables either function and the system
detects that the OTHER function is already ON, the system will automatically turn the OTHER conflicting function OFF.
Left Display: Where (2) items shown, e.g. RUN- / IN, the display will alternate (flash) between the (2) items
Right Knob Selection
Art # A-10505_AB
TIG
Process
MIG
STICK
Advanced
Features
Figure 3-5: MIG Advanced Menu