Tweco 252i Fabricator - Manual (Page 60)

FABRICATOR 252i INSTALLATION/SETUP
INSTALLATION/SETUP 3-30 Manual 0-5155
3.21 Set-up for STICK Metal Arc Welding (SMAW)
!
WARNING
Before any welding is to begin, be sure to wear all appropriate and recommended safety equipment.
NOTE
The following set up is known as DC Electrode Positive or reverse polarity. Please consult with the
STICK electrode manufacturer for specific polarity recommendations.
1. Switch the ON/OFF Switch (located on the rear panel) to OFF.
2. Attach the STICK and Work Leads as shown in Figure 3-24.
+
-
Negative Output
Terminal
(Dinse® type 50)
Art # A-10553
Figure 3-24: Setup for STICK Welding reverse polarity shown.
3. Set the welding process to STICK.
4. Set the Weld Current Control Knob to the desired amperage.
5. Install a STICK electrode in the electrode holder.
6. You are now ready to begin STICK Welding.
NOTE
To weld, gently strike the electrode on the work piece to generate a welding arc, and slowly move along
the work piece while holding a consistent arc length above base metal.