Tweco 9-8587 - Manual

Manual 0-5185 1
Scope
This kit is for use only with Victor Thermal Dynamics
CutMaster TM P lasma Cutting Power Supplies listed above.
Do not use this kit with any other equipm ent.
Supplied Parts
The kits include:
• Contactor
• Contactor, 2 piece enclosure
• Contactor, coil harness
• Contactor wires
• Installation instructions
Tools Required
T-20 Torx driver with minimum 4” (100mm)
Needle nosed pliers
Diagonal cutters.
Instructions
WARNINGS
Disconnect primary power at the source before
performing any inspection or repairs.
Only a qualified technician should perform
this procedure.
Follow the electrostatic discharge instructions
included with the component to prevent dam-
age to the component.
Main PCB Removal
NOTE:
Keep all hardware for remounting and attach-
ing components and wires.
Throughout the rest of this instruction guide
the terms “Smaller” and “Larger” will be used
referring to the power supply as follows:
Smaller - CM52, CM82, A40, A60, 12mm,
20mm and 25mm
Larger - CM102, CM152, A80, A120, 35mm
and 40mm
1. Remove the power supply cover. 10 Torx screws. Do
not lose any and note the difference in them and where
they came from. See following two illustrations.
Upper
Screws
Lower
Screws
Lower
Screws
Art # A-08317
Slots
Figure 1
Original Publication Date: 2011 Manual no.: 0-5185
Revision Date: 3/18/2014 Revision: AD
CutMasterTM 52, 82, 102, 152,
A40, A60, A80, A120, 12mm,
20mm, 25mm, 35mm and 40mm
Replacement Kit: 9-8587
Installation Instructions