SARGENT Wall & Frame Switch - Manual

4341 EXIT BUTTON
INSTALLATION & OPERATING
INSTRUCTIONS
FOR ASSISTANCE, CALL SARGENT AT 1-800-810-WIRE (9473)
1
1. DESCRIPTION
The model 4341 is a surface mount momentary rectangular exit button without indicators which is often used as a receptionist’s
button mounted on the underside of a desk.
The NO and NC (DPST) contact switch when the button is depressed and return when it is released. The switch is UL listed with
3 AMP capacity. Note that the switch type is double pole double throw. Two of the contacts are not factory wired (See drawing on
the second page) since all six contacts are rarely required. This also provides less factory wiring and a less crowded hookup. The
installer may use these contacts by soldering on leads.
The 4341 can be used for momentary release of fail safe or fail secure electric locks. If interfaced with a timer, such as the
SARGENT TMR2 or TMR9, it can provide for timed release of electric locks. It may also be used to input an REX (request to exit)
signal to a card reader system. We recommend that the local building or fire safety authority be consulted prior to using exit
buttons for door egress. They may require a "no special knowledge" exit device such as SARGENT 80 Series exit device with a
REX switch (55-).
2. INSTALLATION
The 4341 comes with color coded hookup wires installed. The drawing on the second page shows identification of the unit's
connection points.
**Securitron is an ASSA ABLOY Group Co.
Copyright © SARGENT Manufacturing. All rights reserved.
Reproduction in whole or in part without the express written
permission of SARGENT Manufacturing is prohibited.
A7865B