SARGENT 1331 Series Aluminum Closer User Manual
Page 6
6
3
2-1/2"
1-7/8"
1-1/4"
5/8"
1/2"
3/4"
3-1/2"
12"
With fasteners provided, install foot to frame
with nut as shown and closer body to door
with
power adjustment toward hinge
1331 JPH9 PARALLEL HOLD OPEN INSTRUCTIONS
2
4
Open door and insert foot into main arm. Close door fully, while holding elbow 1-1/4" from door. Tighten arm bolt
1-1/4"
Arm bolt
Determine maximum degree of door opening required.
Use a #16 drill. Drill and tap door and frame for 12-24 machine
screws. When using the included self tapping screws, predrill
with a 3/32" drill.
Frame
Door
IMPORTANT
Nut faces
down for
left hand
and faces
up for right
hand door
Cover
Use 1331-D Drop
bracket if door
rail is too narrow
3
Center line
of hinge
Center line
of hinge
Center line
of hinge
Right hand shown, left hand opposite.
*
(120° - 3-3/4")
180° - 1-3/8"
*
(120° - 9-1/2")
180° - 7-1/8"
5
See page
5 for
adjustment
and cover
installation
Accessory Information
2-1/2" Min.
1331D
Drop plate used when
top rail is less than 2 1/2"
581-1 Blade Stop Spacer Kit
Metal spacer for use on 1/2"
blade stops on aluminum
store fronts
Drop Plate
*Provides maximum power for
heavy or drafty doors
With wrench on bottom
spindle, preload/index by
turning spindle as shown
and secure main arm to top
spindle with flat mark as
indicated at left with screw
and washer
Left Hand
Door
Right Hand
Door
Flat
mark
Copyright © 2008, Sargent Manufacturing Company, an ASSA ABLOY Group company. All
rights reserved. Reproduction in whole or in part without the express written permission of
Sargent Manufacturing Company is prohibited.
A7742A
Copyright © 2008, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights
reserved. Reproduction in whole or in part without the express written permission of Sargent
Manufacturing Company is prohibited.
A7742A
1