SARGENT 9900 Series Mortise Lock - Manual (Page 2)

700 S E R IE S FR E E W H E E LIN G LE V E R H A N D LE C O N T R O L
METHOD FOR CHANGING HAND OF LEVER
1. REMOVE STOP SCREW USING PHILLIPS SCREWDRIVER.
2. REMOVE HUB SPRING FROM THE GROOVE PIN.
3. REMOVE GUIDES.
4. REMOVE TRUSS HEAD MACHINE SCREW, LOCKING SLIDE SPRING AND LOCKING SLIDE.
5. REMOVE RETAINING RING AND DISCARD.
6. REMOVE SPINDLE LOCKING HUB.
7. REMOVE LOWER HUB PLATE. REMOVE SPRING FROM THE HUB PLATE.
8. ROTATE HANDLE TO DESIRED HAND.
(SPINDLE DOES NOT HAVE TO BE REMOVED TO CHANGE HAND).
9. REASSEMBLE BY FLIPPING LOWER HUB PLATE OVER.
(SO THAT SPRING RETAINING HOLE IS ON THE OPPOSITE SIDE).
ASSEMBLE LOWER HUB PLATE WITH HUB SPRING BEFORE SLIDING IT DOWN SPINDLE.
10. INSTALL SPINDLE LOCKING HUB.
11. INSTALL NEW RETAINING RING ONTO SPINDLE.
12. INSTALL LOCKING SLIDE, LOCKING SLIDE SPRING AND TRUSS HEAD MACHINE SCREW.
13. INSTALL GUIDES.
14. INSTALL HUB SPRING ONTO THE GROOVE PIN.
15. INSTALL STOP SCREW INTO THE HOLE FACING THE LEVER HANDLE.
METHOD FOR REPLACING CYLINDER
1. WITH LOCKING SLIDE IN DOWN POSITION, UNSCREW CYLINDER NUT AND
REMOVE THE CYLINDER AND CYLINDER RING.
2. REPLACE CYLINDER BY REVERSING ABOVE PROCEDURE.
MAKE SURE THAT CYLINDER CAM POINTS UP AND CORRECT LENGTH OF RING IS USED.
700 SERIES RH FREEWHEELING ET CONTROLS SHOWN
CYLINDER
CYLINDER
RING
CASE
CYLINDER
NUT
LOCKING
SLIDE
LOCKING SLIDE
SPRING
TRUSS HEAD
MACHINE
SCREW
FLAT HEAD
MACHINE SCREW
RETAINING
RING
SPINDLE
GUIDE
LOCKING
HUB
HUB SPRING
LOWER
HUB
PLATE
STOP
SCREW
CAP NUT
GROOVE
PIN
SPINDLE
BUSHING
INSERT
LEVER
HANDLE
700-4 FREEWHEELING
ET CONTROL
700-6 FREEWHEELING
ET CONTROL
700-8 FREEWHEELING
ET CONTROL
Copyright © SARGENT Manufacturing. All rights reserved.
Reproduction in whole or in part without the express written
permission of SARGENT Manufacturing is prohibited.
A7261E