SARGENT 8500 Narrow Design Rim Exit Device User Manual
Page 4
4
7
6
APPLY COVERS
(-53) LATCH BOLT MONITERING
ADJUSTMENT
ATTACH END CAP TO
MOUNTING PLATE WITH (2)
COVER SCREWS
SCREW PACKS AND MISCELLANEOUS PARTS
Copyright © 2009-2012, Sargent Manufacturing Company,
an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written
permission of Sargent Manufacturing Company is prohibited.
A6699N
ATTACH COVER THRU RAIL INTO CHASSIS
WITH (2) #8-32 TRUSS HEAD SCREWS
Note: The latch bolt switch will come pre-set for the most
common applications. If the sensitivity needs to be adjusted,
follow the steps below.
1. Loosen screw and nut
2. Rotate switch
(up for quicker
reaction or down for
slower reaction).
3. Tighten screw and nut
4. Check operation
5. Install chassis cover
NOTE: Make sure switch is located on the mounting post and
the screw and nut are securely fastened
ATTACH COVER TO
CHASSIS WITH (2)
COVER SCREWS
Using your mobile phone,
scan this Microsoft
®
Tag.
Download the free mobile app
at http://gettag.mobi