SARGENT AL - Alarmed Exit - Manual

Installation and Wiring Instructions for the TL- Prefix
SARGuide Illuminated Touchpad for 80 Series Exit Devices
to ElectroLynx™ Connector System
U.S. Patent No. 7,204,050
For assistance, contact SARGENT at 800-810-WIRE (9473) or www.sargentlock.com
A. Function
The SARGuide exit device contains an illuminated touchpad to enhance the visibility of exit locations in dark or
smoke-filled passages and is intended as a supplement to existing codes for egress lighting.
B. Important
1. Caution: Disconnect all input power before beginning installation to prevent electrical shock and
equipment damage.
2. Installer must be a trained, experienced service person.
3. All wiring must comply with applicable local electrical codes, ordinances and regulations.
C. ElectroLynx Connector System Notes:
The system is designed to be installation friendly with
connectors from the electric hinge through the door to
the rail. The only wiring required is to the loose wires
on the pigtail harness assembly on the frame side of
the electric hinge.
IMPORTANT:
The plug and receptacle connectors are designed to
mate and lock together as shown in the figure. Plug
the connectors into each other with the locking
mechanism aligned as indicated.
Do NOT force connectors on any other way.
1
SARGuide TL- 80 Series Rail
with 4-pin connector
4 2
3 1
1, Violet (-24)
2, Grey (+24)
EXIT EXIT EXIT
D. Installation Notes
1. With new applications, a raceway harness with 8 & 4-pin connectors will be pre-installed inside door by
ASSA ABLOY door manufacturer when specified during ordering process. Raceway harness kits are also
available for retrofit applications. For retrofit applications, refer to retrofit instructions.
2. If door does not have a raceway harness with connectors, either consult factory for raceway retrofit kit, or cut
the connectors off product and hard wire as required.
2. Wiring to pigtail harness is per facility wiring requirement. The rail, raceway, electric hinge and pigtail connector
terminations and wire colors all match.
1 Copyright © 2009, SARGENT Manufacturing. All rights reserved.
Reproduction in whole or in part without the express written
permission of SARGENT Manufacturing is prohibited.
A7711C - 5-1-9