SARGENT 5800 & 12-5800 Alarmed Exit Hardware - Manual

FOR 28- D-LL(LP.LB) – DUMMY PULL
28-K-LL(LP,LB) – KEY RETRACTS LATCH BOLT
28-N-LL(LP,LB) – LEVER OPERATES ONLY WHEN KEY IS INSERTED AND TURNED
28-C-LL(LP,LB) – CYLINDER LOCK & UNLOCKS LEVER
28-L-LL(LP,LB) – PASSAGE - LEVER ALWAYS OPERATIVE
NOTE: THE TRIM IS FACTORY ASSEMBLED
FOR RIM AND VERTICAL ROD SERIES
EXIT DEVICES
1. REMOVE TWO SCREWS
2. ROTATE MOUNTING
PLATE 90
° CLOCKWISE
3. REPLACE SCREW
POSITION FOR RIM AND VERTICAL ROD SERIES
EXIT DEVICES
POSITION FOR 5100 - 5800 & 12-5800 EXIT ALARMS
VR & RIM
AL-RM VR & RIM
AL-RM
ROSE SCALP
STEP 1.
MOUNTING
PLATE
OUTSIDE
ROSE ASS'Y
PUSH PIN
(PROVIDED)
KEY
LEVER
CATCH
OUTSIDE
SUPPORT
PLATE
OUTSIDE LEVER
STEP 2.
STEP 3.
TWO PILOT
HOLES 3/32'' DIA.
#6 x 3/4''
PHILLIPS
PAN-HEAD
SHEET
METAL
SCREWS
STEP 4.
LEVER
CATCH
ROSE
SCALP
LANCE
OUTSIDE
ROSE ASS'Y
LANCE
DETENT
POSITION
CHASSIS
OUTSIDE
ROSE ASS'Y
LEVER
CATCH
TAB OF
SUPPORT
PLATE
OUTSIDE
SUPPORT
PLATE
TUBE
ASSEMBLY
MOUNTING
PLATE
#10 -32 PAN
HEAD MACHINE
SCREWS
ROSE SCALP INSTALLATION
1. SLIGHTLY LOOSEN THE TWO #10-32'' SCREWS FROM INSIDE.
TWIST THE SCALP IN PLACE AS SHOWN.
2. TIGHTEN THE TWO #10-32 SCREWS SECURELY AT THIS TIME.
REMOVE LEVER AND ROSE SCALP
1. TURN KEY COUNTER CLOCKWISE AS FAR AS IT WILL GO.
(FOR 04, 06, & 13 FUNCTION)
2. TURN KEY 45 ° CLOCKWISE.
3. DEPRESS LEVER CATCH THROUGH HOLE IN LEVER. (FOR ALL FUNCTION)
4. SLIDE LEVER FROM THE TUBE.
5. REMOVE ROSE SCALP.
DISASSEMBLY OF TRIM
BEFORE INSTALLING
INSTALLING TRIM
INSERT UNIT IN 2-1/8'' HOLE (LEVER CATCH HAS TO FACE EDGE OF
DOOR). BE SURE THE TWO TABS OF SUPPORT PLATE ENGAGE TWO
NOTCHES IN 2-1/8'' HOLE. THRU BOLT CHASSIS TO TUBE ASEMBLY
WITH (2) #10-32 SCREWS. DO NOT TIGHTEN SCREWS AT THIS TIME.
SECURE TRIM TO DOOR
1. DRILL TWO PILOT HOLES 3/32'' DIA. THROUGH SUPPORT PLATE
AT LOCATION SHOWN.
2. SECURE TRIM TO DOOR WITH TWO #6 x 3/4'' SCREWS PROVIDED.
Instructions for Trim Installation
For assistance, contact SARGENT at 800-810-WIRE (9473) or www.sargentlock.com
1
A7274B
Copyright © SARGENT Manufacturing. All rights reserved.
Reproduction in whole or in part without the express written
permission of SARGENT Manufacturing is prohibited.