SARGENT 5800 & 12-5800 Alarmed Exit Hardware - Manual (Page 2)

INSTALLING TRIM
INSERT UNIT IN 2-1/8'' HOLE (LEVER CATCH HAS TO FACE EDGE OF DOOR). BE SURE THE TWO
TABS OF SUPPORT PLATE ENGAGE TWO NOTCHES IN 2-1/8'' HOLE. SNUG UP SCREWS AT THIS
TIME, NOT TIGHT TO CHASSIS WITH TWO #10-32 SCREWS AS SHOWN.
28-D-LL(LP, LB) – DUMMY PULL
OUTSIDE
LEVER
ROSE
SCALP
LANCE
RECESS
OUTSIDE
ROSE ASS'Y
RETAINER
PUSH PIN
(PROVIDED)
#10-32 x 1-1/4''
PHILLIPS PAN HEAD
MACHINE SCREWS
MOVE 2 SCREWS TO
LEFT SIDE OF DOOR.
CONT'D FROM FRONT PAGE
STEP 5.
INSTALL LEVER
1. INSERT FLAT SCREWDRIVER INTO SLOT OF KEY CAM AND TURN
ALL THE WAY COUNTER CLOCKWISE.
2. WITH KEY PARTIALLY REMOVED FROM CYLINDER, PUSH LEVER
ON TUBE AS FAR AS IT WILL GO.
3. COMPLETELY INSERT KEY AND TURN 45 ° CLOCKWISE.
PUSH LEVER AGAIN UNTIL LEVER CATCH IS ENGAGED,
SECURING THE LEVER, PULL ON IT TO BE SURE LEVER
CATCH IS IN PLACE.
4. CHECK FOR PROPER OPERATION: TURN KEY FULLY
CLOCKWISE OR COUNTER CLOCKWISE. KEY WILL REMOVE
IN A HORIZONTAL POSITION WITH BITTING (NOTCHES)
TOWARD HINGE SIDE OF DOOR.
2
Copyright © SARGENT Manufacturing. All rights reserved.
Reproduction in whole or in part without the express written
permission of SARGENT Manufacturing is prohibited.
A7274B