Wheatheart X Series 13 Augers User Manual
X-series 13" augers
Advertising
Table of contents
Document Outline
- 1. Introduction
- 2. Safety
- 3. Assembly
- 3.1. General Assembly
- 3.2. Identify Auger Tube Sections
- 3.3. Assemble the Main Auger Tube
- 3.4. Install the Boot on the Auger tube
- 3.5. Install Boot Bearing, Lower Sprocket, and Drive Chain
- 3.6. Install the Boot Tow Bar
- 3.7. Install the Discharge Spout
- 3.8. Set the Thrust Adjuster
- 3.9. Apply Logo and Model Decals
- 3.10. Auger Tube Truss Assembly
- 3.11. Assemble the Auger Frame
- 3.12. Installing the Hydraulic Cylinders
- 3.13. Assemble Wheel Hubs and Install Tires
- 3.14. Attaching the Auger Tube to the Frame
- 3.15. Connecting Hydraulic Hose to Cylinders
- 3.16. Install Low Profile Intake Hopper
- 3.17. Installing the Hopper Lift Arm and Winch
- 3.18. Install the Hitch Jack
- 3.19. Connecting the PTO Driveline
- 3.20. Auger-to-Tractor Hookup
- 4. Transport
- 5. Placement
- 6. Operation
- 7. Maintenance
- 7.1. Maintenance Intervals
- 7.2. Fluids and Lubricants
- 7.3. Maintenance Procedures
- 7.3.1. Visual Inspection
- 7.3.2. Hydraulic Hose and Coupler Inspection
- 7.3.3. Machine Greasing
- 7.3.4. Hopper Lift Cable Inspection
- 7.3.5. Winch and Pulley Servicing
- 7.3.6. Swing Tube Coupler Chain Servicing
- 7.3.7. Boot and Hopper Chain Drive Servicing
- 7.3.8. Gearbox Oil Level
- 7.3.9. Machine Cleaning
- 7.3.10. Tire Pressure Check
- 7.3.11. Wheel Bearings Repack
- 7.3.12. Wheel Bolt Tightening
- 7.3.13. Cable Adjustment (X130-74)
- 7.3.14. Cable Adjustment (X130-84, X130-94)
- 7.3.15. Changing Gearbox Oil
- 8. Storage
- 9. Troubleshooting
- 10. Appendix
- Warranty Registration
- Limited Warranty