Wheatheart S2000 Post Pounder - Manual (Page 35)

W HEATHEART - P OST P OUNDER 4. T RANSPORT
S2000 M ODEL
IM15 R1 35
4. Transport
Follow this procedure when placing the unit into its transport position:
1. Slowly back the tractor up to pounder, leaving at least 6” clearance between
tractor Category II or III 3-point hitch and pounder.
2. Adjust height of 3-point hitch, ensuring that attach points on tractor are not
lower than attach points on pounder.
3. Slowly back tractor up to pounder the remaining distance and attach to
Category II or III 3-point hitch with supplied hitch pins.
4. Once pounder is fully attached to tractor, lift jacks into transport position and
secure with hairpins.
5. Raise the pounder to a safe transport height using the 3-point hitch.
6. Before transporting, ensure hammer/ballast box is positioned in the fully
lowered position, and the mast is fully tipped back and secured by lockbars.
7. Make sure the SMV (Slow Moving Vehicle) emblem and lights and reflectors
that are required by the local authorities are in place, clean, and clearly
visible to all traffic.
8. Consult with local authorities regarding transport on public roads. Obey all
applicable laws and regulations.
Important: Use caution when turning corners or meeting traffic.
Warning: Before continuing, ensure you have read and understand the relevant information
in the safety section. Safety information is provided to help prevent serious injury, death, or
property damage.
CAUTION
Ensure hitch connection points on tractor and
pounder are level and aligned with each other
before proceeding, to prevent tipping the
pounder and potential injury.
WARNING
Do not attempt to move the unit by hand. Only
move when hitched securely to tractor.
WARNING
Use extreme care and use minimum ground
speed when operating or transporting on
hillsides, over rough ground, or near ditches
or fences.