Great Plains 2S-2600HDF Predelivery Manual - Manual (Page 14)

12 2S-2600HD Great Plains Manufacturing, Inc.
195-069Q 08/01/2007
Wing Fixed Step Decals
If the drill is equipped with a swing-down ladder, skip
these steps and use the instructions at “Wing Swing-
Down Ladder Decals” on page 12.
Refer to Figure 9
Starting on the left wing walkboard:
1. If an 838-102C Danger Falling Hazard decal is
separately provided, place it on the outside end of the
walkboard, just aft of the step’s vertical riser, where it
is visible to climbers.
2. Place one 838-265C Amber decal on the outside
(step) end of the walkboard
. Align the rear end of
the decal with the walkboard corner.
3. Place one 838-265C Amber decal on the rear face of
the walkboard, step end
. Align the rear end of the
decal with the walkboard corner.
4. Repeat for right wing section walkboard.
5. Skip to “Other Assembly Items” on page 13.
Wing Swing-Down Ladder Decals
Refer to Figure 10
Starting on the left wing walkboard:
1. If an 838-102C Danger Falling Hazard decal is
separately provided, place it forward of and near the
top of the ladder, where it is visible to climbers.
2. Place one 838-265C Amber decal on the outside of
the ladder mount, between the ladder side plates
(so it won’t be damaged by ladder operation).
3. Place one 838-265C Amber decal on the rear and
corner
of the ladder mount. This decal is slightly
longer than that side of the mount. Wrap the excess
around the corner.
4. Repeat for right wing section walkboard ladder.
Figure 9
Fixed Step Ladder Decals
27017
3
1
2
1
2
3
Figure 10
Swing-Down Ladder Decals
27016
3
1
2
1
2
3