Great Plains 2S-2600HDF Predelivery Manual - Manual (Page 29)

Great Plains Manufacturing, Inc. Setup 27
08/01/2007 195-069Q
Install Final Accessories
Acremeter Installation
Refer to Figure 31
The acremeter is supplied from the factory in a sepa-
rate carton, to minimize risk of shipping damage. It is
installed on the left end of the left drive shaft.
Screw the threaded end of the meter into the 1 ⁄
2
-20
tapped hole in the left end of center main drive shaft.
Tighten the threaded end only enough to prevent it from
working loose from normal vibration. In use, there is no
torque or tension that might tend to unscrew it.
The acremeter counts shaft rotations whenever the shaft
is rotating - normally this is only with the drill unfolded, the
opener sub-frame lowered, and the drill in motion. The
meter is geared to display rotations as acres, when using
factory-specified tires and inflations.
Tally field acres by noting the meter reading prior to, and
after planting. Subtract the starting from the ending read-
ings.
Open Center Conversion
If the drill was shipped with an Open Center kit, it is not
factory-installed. Install it now. An installation manual is
provided.
Figure 31
Acremeter Installation
27000
2 1
1
2
Figure 32
Open Center Conversion
18750