Great Plains 2S-2600HDF Predelivery Manual - Manual (Page 8)

195-069Q 08/01/2007
6 2S-2600HD Great Plains Manufacturing, Inc.
Preparation
Step-by-step instructions for assembling the implement
begin in the next section of the manual. Before commenc-
ing work, review the Tools Required and Pre-Assembly
Checklist to make sure you have all necessary parts and
equipment.
The implement is shipped via flat bed truck. It is the
dealer’s responsibility to unload the new machine. Unload
all equipment before beginning assembly.
Overview of Work
The drill is shipped substantially assembled, less wing
walkboards, press wheel arms, press wheels, walkboard
reflector decals, accessories and some options.
All fasteners and misc. components are located in their
assembly location, or in bags/cartons inside a drill seed
box.
Assembly
1. Unload truck.
2. Install walkboards
3. Install steps/ladders
4. Apply decals.
5. Install press wheels.
6. Install optional components that were not factory-
installed, but need to be present prior to first hydrau-
lic operations, such as By-Pass or Two-Outlet.
Setup
7. Hitch to suitable tractor.
8. Connect hydraulics.
9. Bleed hydraulics.
10. Level drill.
11. Install acremeter.
12. Install any other components or options not factory-
installed, or which need to be installed after first
unfolding, such as Point Row.
Tools Required
• Forklift, loader or overhead hoist with a capacity of:
at least 13,000 pounds (5900 kg)
• A tractor of sufficient size and horsepower with at least
two remote hydraulic circuits. Refer to “Specifications
and Capacities” in the Operator’s Manual.
• General hand tools
• Jack stands or blocks and safety chain
Note: You will need about 4.5 gallons of hydraulic oil to
refill the tractor hydraulic reservoir after initial
bleeding and cycling of the hydraulic systems.
IMPORTANT !
Do not attempt any assembly work while the imple-
ment is on the truck.