Great Plains 2S-2600HDF Predelivery Manual - Manual (Page 15)

Great Plains Manufacturing, Inc. Assembly 13
08/01/2007 195-069Q
Handles and Lights
Install Box Handles
Refer to Figure 11
On outside ends of drill boxes, bolt handles to boxes.
Use
1 ⁄
2
in hex-flange screws and lock nuts.
Install Warning Lights
Refer to Figure 12
On inside ends of drill boxes, bolt warning lights to boxes.
Use
1 ⁄
2
in hex-flange screws and lock nuts.
Plug warning-light leads into drill harness .
Check lights for correct installation after making electrical
connections (page 18).
Fold drill, then check that both lights have an amber and
a red lens facing toward rear of drill. If necessary, re-
install lights properly.
Other Assembly Items
There are a few additional standard components, and
several possible optional items, that are not factory
installed. Some of these, which follow in this chapter,
need to be installed prior to first hydraulic hookup. Others
are installed after hookup, bleeding and leveling. See
“Install Final Accessories” on page 27.
Figure 11
Box Handle
17347
Figure 12
Warning Lights
17346
1
2
1
2