Great Plains 2S-2600HDF Predelivery Manual - Manual (Page 28)

26 2S-2600HD Great Plains Manufacturing, Inc.
195-069Q 08/01/2007
Wing Box Alignment
1. Place a block ahead of the wing gauge wheels.
Refer to Figure 29
2. Pull forward against blocks to rock wing frames back.
Pull forward until stop bolts
are firmly against tool-
bars.
Refer to Figure 30
3. Check for proper alignment by running a string line
across back of drill toward outer ends of wings.
4. For proper alignment, outside ends of boxes
should be about 1in (2.5cm) ahead of inside ends
.
5. To adjust box alignment, shorten or lengthen stop
bolts
to change the contact point with the toolbars.
Loosen jam nut and thread stop bolt in or out. Adjust
stop bolts in or out until outside ends of boxes are
1in (2.5cm) ahead of inside ends.
6. Tighten jam nut.
Figure 29
Stop Bolts (Wings Folded)
17357
1 1
Figure 30
Wing Box Alignment Measurement
17300
1
A
B
1