Great Plains 2S-2600HDF Predelivery Manual - Manual (Page 31)

Great Plains Manufacturing, Inc. Setup 29
08/01/2007 195-069Q
Shaft Monitor
Refer to Figure 35
If the drill was ordered with the optional shaft monitor,
install the sensors and leads per the included installation
manual.
If the primary tractor is available, also install the display
console in the cab.
Scraper Installation
1. Remove one or both disk blades to gain safe access
to the mount. Note the position of bushings and spac-
ers for correct re-assembly.
Refer to Figure 36
2. Position the inside scraper mount to the rear of the
seed firmer mount on the opener weldment.
Secure it with two HHCS 3 ⁄
8
-16x1in hex head bolts,
lock washers and nuts. Insert the bolts from the front.
3. Position the scraper blade below and behind the
inside scraper mount , with the notch on top to
machine right.
Secure it loosely with one RHSNB 3 ⁄
8
-16x1 round
head square neck bolt, flat washer, lock washer and
nut.
4. Re-mount the removed disk blade.
Figure 35
Shaft Monitor
18943
26468
Figure 36
Scraper Installation
26460
2
1
3
1
2
3
1