Great Plains 3P4025AH Operator Manual - Manual (Page 123)

Great Plains Manufacturing, Inc. Table of Contents Index Appendix C - Setup 119
2014-07-29 Table of Contents Index 411-099M
Refer to Figure 104
13. Use the Left and Right Arrow keys (
or ) to
select the digits to modify. Use the Up or Down
Arrow keys (
or ) to increment or decrement.
Change the row count to the table value for your
planter model and operating configuration.
14. Press the ENTER key to save the correct row
count.
Set Planter Row Spacing
15. Press the Down Arrow key to select the Row
Spacing field .
16. Use the Left and Right Arrow keys ( or ) to
select the digits to modify. Use the Up or Down
Arrow keys (
or ) to increment or decrement.
Change the row spacing to the value for your planter
model (70 cm). Planter swath
(“5.60”) is
automatically calculated.
17. Press the ENTER key to save the corrected row
spacing.
Row Setup
The planter row setup defaults to the number of rows
detected (8), and defaults to population mode
on
every row. For canola, mustard and volumetric seeds,
configure the rows for blockage
.
This completes initial setup of the PM400 console. Press
the On/Off button
to power-down.
Note: For twin-row configurations, enter the row spacing
as one half the nominal twin spacing.
For a 30 inch twin row, enter 15 inches.
For a 70 cm twin row, enter 35 cm.
Figure 104
Twin Row Spacing Configuration
36083
a
b
c
b
c