Great Plains 3P4025AH Operator Manual - Manual (Page 29)

Great Plains Manufacturing, Inc. Table of Contents Index Operating Instructions 25
2014-07-29 Table of Contents Index 411-099M
Refer to Figure 16
1.
Hitch tractor (page 15).
2. Move to level ground. Be aware of vertical clearance
needed to fold planter.
3. Put tractor in Park with parking brake engaged.
4. Install the flex lock pin
(installed in inner wing pivot assembly).
5. Remove the wing lock pin (if installed).
Machine Damage Risk:
Wing pins must be inner-in and outer-out during wing folding
and unfolding, or machine damage will occur.
6. Clear all persons from on or near the planter.
Refer to Figure 15
7.
Use the tractor 3-point hitch to raise the planter until
all row units clear the ground.
8. Extend the lift-assist circuit (if present) to raise the
rear of the planter.
9. Slowly move fold circuit lever to Retract. Observe the
fold operation.
10. Wait for both wings to reach the fully folded position.
Set tractor remote to Neutral to hold at folded.
Figure 16
Lock Pins for Fold
36035
2
1
1
2