Great Plains 3N-4025P Operator Manual - Manual (Page 31)

4/23/2010 196-286M
29 Operating Instructions
Parking
For information on long-term storage, refer to
“Storage”, page 80.
1. Fold the drill. Refer to “Folding the Drill,” page
22.
2. Park the drill on a level, solid area.
3. Securely block the tires to prevent rolling.
Refer to Figure 19
4. Remove the jack from its storage stob. Pin the
jack in parking position. If the ground is soft,
place a board or plate under the jack.
5. Extend the jack until tongue weight is off the
drawbar.
6. Unplug the hydraulic lines from the tractor. Do
not allow hose ends to rest on the ground.
7. Unplug the drill light cable from the tractor.
8. Unplug monitor harness from console.
9. Remove hitch pin and safety chain from trac-
tor drawbar.
There is not enough weight on jack to anchor drill.
Drill wheels must be blocked when unhitching from
tractor. DO NOT unhitch drill while on a steep slope.
Always unhook safety chain LAST!
20273
Figure 19
Jack in Parking Position