Great Plains 3N-4025P Operator Manual - Manual (Page 71)

4/23/2010 196-286M
69 Maintenance and Lubrication
Shutting Off Seed Flow
Refer to Figure 93
To shut off seed flow, move front seed tubes back-
ward and back seed tubes forward. The following
instructions explain how to shut off seed flow to
each meter.
Refer to Figure 94
1. Remove the retaining clip and pull pin. Do not
remove cotter pin.
Refer to Figure 95
2. Move meter cap to position seed tube over
shut off pad.
3. Place pin in hole of meter cap and install re-
taining clip.
4. Repeat steps 1 through 3 for each meter.
NOTE: When pin with retaining clip is located
in the slot, sliding seed tube is open. When pin
with retaining clip is located in the hole, slid-
ing seed tube is closed.
18290
Shut off
Shut off
Sliding seed
tubes
18302
Retaining
clip
Shut off
pad
Sliding seed
tube
18303
Retaining
clip
Sliding
seed tube
Figure 93
Figure 94
Figure 95