Great Plains 800EW Operator Manual - Manual (Page 12)

10 175-248A, -249A, -250A, -251A
175-253M 02/24/2010
Remove Small Seeds Delivery Tubes
If Small Seeds (SGS) is not installed on this drill, con-
tinue at step 21 on page 11.
The existing SGS delivery tubes occupy the row unit hole
required for fertilizer. New SGS side delivery hardware is
installed at step 70 on page 19.
16. At each row, remove two:
801-002C SCREW HEX SLT10-16X1/2P.THD CT
and one
123-939H SMALL SEEDS TUBE WELDMENT
These parts are not re-used.
Remove Small Seeds Box
If Small Seeds (SGS) is not installed on this drill, con-
tinue at step 21 on page 11.
The Small Seeds box is re-mounted, on the new Fertil-
izer box, at step 63 on page 18.
Refer to Figure 11 (shown in exploded view for clarity - re-
move only specified fasteners - in particular, do not remove the
jackshaft and final drive assembly at the left end)
17. At each base of the box end mount , remove and
save one sets (two sets total):
802-034C HHCS 1/2-13X1 1/4 GR5
804-015C WASHER LOCK SPRING 1/2 PLT
803-020C NUT HEX 1/2-13 PLT
18. Support the weight of the Small Seeds box.
19. At the upper forward faces of each base of the box
end mount , remove and save two sets (four total):
802-203C HFSS 1/2-13X1 1/2 GR5
803-169C NUT HEX FLG. LOCK 1/2-13 PLT.
20. Remove the Small Seeds box from the drill.
Figure 10
Remove Small Seeds Delivery
28212
25
U
D
L
R
B
F 14
25
14
Figure 11
Dismount Small Seeds Box
28098
28
44
30
38
4
37
CAUTION !
A hoist or at least three (3) people are required. The empty
Small Seeds assembly weighs approximately 200 pounds (91
U
D
B
F
R
L
4
28
44
37
4
30
38