Great Plains 800EW Operator Manual - Manual (Page 5)

3
02/24/2010 175-253M
Safety Decals
Safety Reflectors and Decals
The kits covered by this manual may include new safety
decals that need to be applied. Existing safety decals on
the drill also apply during the installation. Both classes of
decals are re-listed here for emphasis.
▲ Read and follow decal directions.
▲ Keep lights in operating condition.
▲ Keep all safety decals clean and legible.
▲ Replace all damaged or missing decals. Order new decals
from your Great Plains dealer. Refer to this section for
proper decal placement.
▲ When ordering new parts or components, also request cor-
responding safety decals.
To install new decals:
1. Clean the area on which the decal is to be placed.
2. Peel backing from decal. Press firmly on surface,
being careful not to cause air bubbles under decal.
838-265C
Amber Reflectors
On wing walkboard end faces, above steps,
front face of frame, outside corners;
4 total
Kits include new amber reflectors for new walkboard sup-
ports.
818-019C
Warning: Negative Tongue Weight
Existing decal on tongue at hitch;
1 total
WARNING !
Drill Becomes at Risk of Negative Tongue Weight:
An 800EW drill without the Fertilizer option would always
have positive tongue weight. With the Fertilizer option
installed, negative tongue weight is now possible when mate-
rial is loaded in the fertilizer box, and when weight is on the
new extended walkboard. Unless tractor remains hitched dur-
ing installation, lower drill before unhitching.
28203
28203