Great Plains 800EW Operator Manual - Manual (Page 27)

Close-Out 25
02/24/2010 175-253M
Close-Out
Apply Decals
Refer to Figure 38
108.At the new walkboard supports, clean, de-grease
and dry the outside faces .
109.Select two each new:
838-265C DECAL REFLECTOR AMBER 1 1/2X9
At the right end of the walkboard, peel the release
paper from the back of the decal
, and apply the
decal centered below the two unused holes.
At the left side, similarly apply the other decal (there
may be no holes for alignment).
Check Drive Operation
Refer to Figure 39
110.Check drive system operation with calibration crank.
The crank is now turning the fertilizer flutes as well
as the seed meters, and may require more effort. If
the effort is
• excessive, check for:
• bearing centering and shaft alignment,
• insufficient chain slack,
• lock collar rubbing,
• chain rubbing and binding, and
• fouling of agitator paddles.
111.Perform a fertilizer box rate calibration. Use insert
test material unless fertilizer application is planned
within 24 hours.
112.Readjust chain slack after the first 8 hours of opera-
tion.
Fi S
Figure 38
Apply Amber Decals
29571
1
191
1
238
238
Figure 39
Calibration Crank
28068