Great Plains 800EW Operator Manual - Manual (Page 24)

22 175-248A, -249A, -250A, -251A
175-253M 02/24/2010
Secure Walkboard (w/o SGS)
Refer to Figure 31
91. Select four (4) saved:
802-673C HHCS 7/16-14X1 1/4 GR5 PLT
Insert bolts in rear corner, and center end tread
holes of walkboard .
92. Select six (6) sets saved:
804-014C WASHER LOCK 7/16 PLT
803-015C NUT HEX 7/16-14 PLT
Add lock washers and nuts to all walkboard
bolts.
93. Tighten all walkboard and support bolts.
94. Continue at “Re-Install Ladder” on page 24.
Supports and Walkboard, w/ Small Seeds
Mount LH Support to Walkboard (with SGS)
Refer to Figure 32
95. Select one (1) each new:
142-298D RH WLK BRD SUPP SML SDS-FERT
the saved:
175-411D 8FT EW WALKBOARD
and three (3) sets saved:
802-673C HHCS 7/16-14X1 1/4 GR5 PLT
804-014C WASHER LOCK 7/16 PLT
803-015C NUT HEX 7/16-14 PLT
96. With the break up, and the slotted end to the rear,
mount the LH support under the top left edge of
the walkboard . Insert bolts from above
through tread holes. Loosely secure with lock
washers
and nuts .
Mount RH Support to Walkboard (with SGS)
Refer to Figure 33
97. Select one (1) new:
142-312D LH WLK BRD SUPP SML SDS-FERT
and three (3) sets saved:
802-673C HHCS 7/16-14X1 1/4 GR5 PLT
804-014C WASHER LOCK 7/16 PLT
803-015C NUT HEX 7/16-14 PLT
98. With the break up, and the four-hole end to the front,
mount the LH support under the top left edge of
the walkboard . Insert bolts from above
through tread holes. Loosely secure with lock
washers
and nuts .
Figure 31
Secure Walkboard (w/o SGS)
29572
19
33
33
43
36
33
33
19
43
36
43 36
Figure 32
Walkboard LH Support (w/ SGS)
29573
138
U
D
B
F
R
L
33
19
43
36
138
19
33
43
36
138
19 33
43 36
Figure 33
Walkboard RH Support (w/ SGS)
29573
139
U
D
B
F
R
L
33
19
43
36
139
33
43
36
138
19 33
43 36