Pre-assemble accessory shaft mount, Install accessory shaft mount – Great Plains 800EW Operator Manual User Manual
Page 15
Install Hardware 13
02/24/2010
175-253M
Pre-Assemble Accessory Shaft Mount
34. Select one (1) new:
175-414D 8FT EW AUX JACK SHAFT MNT
two (2) sets new:
802-226C HHCS 1/2-13X2 3/4 GR5
120-305D TUBE RND 1 OD X 7/32W X 1.56
817-406C IDLER 1 PC 2.38X1.01X1.062
803-169C NUT HEX FLG. LOCK 1/2-13 PLT.
and six (6) new:
804-017C WASHER FLAT 1/2 USS PLT
35. Place one washer
, the tube
, the idler
and a second washer
on each bolt
.
36. Insert each idler assembly into the idler slots
the mount
, from the (left) side of the mount
opposite the U-bolt mounting holes
secure with lock washers
and nuts
.
37. Select one (1) new:
822-195C BRG INS 7/8HEXX2.04OD SPH
and two sets new:
822-032C FLANGETTE 52 MST
802-282C RHSNB 5/16-18X1 GR5
804-009C WASHER LOCK SPRING 5/16 PLT
803-008C NUT HEX 5/16-18 PLT
38. Place the bearing
between two flangettes
.
Position assembly against the right side of the mount
at the bearing cutout. Insert bolts
from left, and
loosely secure with lock washers
and nuts
.
Install Accessory Shaft Mount
Refer to Figure 16 (which depicts the completed installation)
39. Select and two (2) new:
806-004C U-BOLT 3/8-16 X 2 X 2 3/4
and four (4) sets new:
804-013C WASHER LOCK SPRING 3/8 PLT
803-014C NUT HEX 3/8-16 PLT
40. Position the accessory shaft mount
, with the
bearing/idler break up and to drill left, on the top of
the front top tool bar
, left of the gearbox. Loosely
secure with U-bolts
, lock washers
and
nuts
.
41. Adjust the mount horizontally until there is a gap of:
2
3
⁄
32
in (52.4mm)
between the left face of the bearing/idler plate and
the right edge of the drill’s end wall breaks
. It may
be necessary to adjust or relocate a cable
reach final mount position.
Figure 15
Accessory Shaft Mount
28230
U
D
B
F
R
L
5
6
103
206
229
206
195
149
188
201
232
235
232
181
206
179
149
179
103
229
195
206
206
103
229
206
179
5
149
6
206
195
235
232
181
201
188
235
232
181
201
188
203
149
190
214
Figure 16
Install Accessory Shaft Mount
29562
3
2
1
4
214
203
190
149
214
203
190
4