Acronis Snap Deploy 5 - User Guide - Manual (Page 109)

109 Copyright © Acronis International GmbH, 2002-2014

Stop without performing deployment to any machine. The task will start at its next scheduled
time and will again begin waiting for the readiness of all machines.
Start condition for deployment
12. Review the task summary, and then click Create to create and save the task.
The task appears in the Deployment tasks view. When the task is started, the connected machines’
IP addresses and the task progress are displayed in that view.
When the task is finished, its log entries will be available in the log of the deployment server.
10.4.2.3 Deployment in another subnet
Machines in another subnet (behind a network switch or router) can be woken up through the
Acronis Wake-on-LAN Proxy component.
If Acronis Snap Deploy 5 OS Deploy Server is installed in one subnet (Subnet 1) and the target
machines in another subnet (Subnet 2), prepare deployment as follows:
1. Install Acronis Wake-on-LAN Proxy in Subnet 2.
2. Prepare Acronis PXE Server in either of these ways:

Install the PXE server in Subnet 2 and configure that PXE server. This way, only machines in
Subnet 2 can boot to the PXE server.
OR