Acronis Snap Deploy 5 - User Guide - Manual (Page 138)

138 Copyright © Acronis International GmbH, 2002-2014
General options
/oss_numbers If this parameter is specified, the numbers of
the volumes in the /partition parameter
are adjusted for the MBR partition table.
This means that primary volumes have
numbers 1-1, 1-2, 1-3, and 1-4 (a disk cannot
have more than four primary volumes);
logical volume numbers start with 1-5.
If this parameter is not specified,
consecutive volume numbering must be
used.
For example, if the disk has one primary
volume and two logical volumes, their
numbers can appear as follows:
/oss_numbers
/partition:1-1,1-5,1-6
or
/partition:1-1,1-2,1-3
Any
/reboot Restarts the machine after the operation is
completed. Cannot be used with the
/shutdown option Any
/shutdown Shuts down the machine after the operation
is completed. Cannot be used with the
/reboot option Any
/log:<file name> Creates a log file of the current operation
with the specified file name Any
/log_net_user:<remote user> If the log file is created in a network folder,
specifies the user name for accessing that
folder Any
/log_net_password:<password> If the log file is created in a network folder,
specifies the password for accessing that
folder Any
14.1.3 Specific parameters (parameters specific for individual
commands)
Option Description
create
/harddisk:<disk number> Specifies the hard disks to include into the image.
An image may contain data of more than one hard disk. In that case,
separate disk numbers by commas, for example:
/harddisk:1,3
To view the list of available hard disks, use the /list command.