Acronis Snap Deploy 5 - User Guide - Manual (Page 36)

36 Copyright © Acronis International GmbH, 2002-2014
Acronis Snap Deploy 5 starts creating the image.
After the image is created, the machine will restart.
Step 5. Performing deployment
In this step, you will deploy the created master image to a single machine (the target machine).
Tip: For getting started, we recommend performing deployment to the same machine from which you created
the image, or to a machine with identical hardware. This way, no extra steps, such as using the Universal
Deploy option, are required.
Preparing the target machine
On the target machine, do the following:
1. Make sure that the CD or DVD drive has a higher boot priority than the hard disk drive. You may
need to open the BIOS setup utility of the machine and adjust the boot priority setting.
2. Boot the machine from the bootable media you created.