Acronis Snap Deploy 5 - User Guide - Manual (Page 137)

137 Copyright © Acronis International GmbH, 2002-2014
14.1.2 Common parameters (parameters common for most
commands)
Parameter Description Image location
Access to images
/filename:<file name> Specifies the full path to the image, including
the file name Any
/password:<password> Specifies the password for the image (if
required) Any
/net_user:<user name> Specifies a user name for accessing the
network drive Network drive
/net_password:<password> Specifies a password for accessing the
network drive Network drive
Imaging options
/incremental Sets the image type to incremental. If this
parameter is not specified or if there is no
basic full image, a full image will be created.
An incremental image stores changes to the
data against the latest image. The name of
an incremental image is the name you
specified in the /filename parameter,
followed by an index; for example:
MasterImage2.tib, MasterImage3.tib, and so
on.
To deploy an incremental image, specify its
name in the /filename parameter of the
deploy command. Make sure that the
image is in the same folder as all images it
depends on.
Any
/differential Sets the image type to differential. If this
parameter is not specified or if there is no
basic full image, a full image will be created.
A differential image stores changes to the
data against the latest full image. The name
of a differential image is the name you
specified in the /filename parameter,
followed by an index; for example:
MasterImage2.tib, MasterImage3.tib, and so
on.
To deploy a differential image, specify its
name in the /filename parameter of the
deploy command. Make sure that the
image is in the same folder as the full image.
Any
/compression:<0…9> Specifies the data compression level. The
compression level ranges from 0 to 9 and is
set to 3 by default Any
/split:<size in MB> Splits the image into parts of the specified
size, in megabytes Any