Acronis Snap Deploy 5 - User Guide - Manual (Page 92)

92 Copyright © Acronis International GmbH, 2002-2014
Example 2. You are deploying a single 100-GB volume. In Target disk layout, you selected to
replace the second (250-GB) volume on the target disk. In this case, the size of the deployed
volume will be 250 GB. The first volume on the target disk will remain intact.
Example 3. You are deploying two 50-GB volumes. Because you are deploying more than one
volume, all volumes on the target disk will be deleted; see “Target disk layout” (p. 90). Each
of the deployed volumes will be 150 GB in size.
Example 4. You are deploying a 10-GB volume and a 20-GB volume. All volumes on the target
disk will be deleted. The deployed volumes will be 100 GB and 200 GB in size, respectively.
Example 5. You are deploying a 1000-GB volume and a 2000-GB volume, both of which
contain little data. All volumes on the target disk will be deleted. The deployed volumes will
be 100 GB and 200 GB in size, respectively. If either volume contains too much data to be
reduced to the respective size, the deployment will fail.

As in the master image: Each deployed volume will have the same size as in the master image.
Any excess available space on the target disk will become unallocated. If the target disk does not
contain enough available space for placing the volumes, the deployment will fail.
Settings preference
The Settings preference setting determines whether individual deployment settings of a machine (p.
131) can override the deployment settings in the template.
When the Settings preference setting is enabled and you set up an individual setting for a machine,
deployment to that machine will be performed with the individual setting, ignoring the
corresponding setting in the template.
When the Settings preference setting is disabled, deployment to all machines will be performed with
the settings in the template, ignoring any individual settings.
Machine name and membership
This setting determines the machine names, also known as NetBIOS names, of the target machines; it
also determines the name of the workgroup or the Active Directory domain to which the target
machines will be added after the deployment.